Secure Checkout

RetroSound In-Dash Speaker, 68-77 Ford Bronco SKU: 6402

RetroSound In-Dash Speaker, 68-77 Ford Bronco

RetroSound In-Dash Speaker, 68-77 Ford Bronco

RetroSound In-Dash Speaker 68-77 Bronco
Purchase RetroSound In-Dash Speaker, 68-77 Ford Bronco
$49.99 SKU: 6402
Fits 68-77 Ford Bronco
9 Reviews

Product Overview:

This RetroSound® Triax™ 5.25-inch dual voice coil dash speaker gives you a stereo mix from your 1968-77 Ford Bronco's single dash speaker location.

Full description

This RetroSound® Triax™ 5.25-inch dual voice coil dash speaker gives you a stereo mix from your 1968-77 Ford Bronco's single dash speaker location.

This RetroSound® Triax™ 5.25-inch dual voice coil dash speaker gives you a stereo mix from your 1968-77 Ford Bronco's single dash speaker location. A treated foam surround delivers the most natural sound possible with no distortion and remarkable durability. Dual mylar tweeters produce crisp, clear highs. •5.25-inch stereo dash replacement speaker
•Stereo mix from your single speaker location
•Treated foam surround for smooth, natural sound
•Dual mylar tweeters for crisp, clear highs
•Poly speaker cone
•Dip-cut magnet for extended pole piece excursion
•30 watts power handling
•Wiring kit included for use with OE factory radios rated at 8 to 10 ohms

TECHNICAL NOTE: You may need to space the speaker off of the back of the dash. The wires on the front of the speaker may make contact with the metal speaker grill. The "stock" dash speaker used a press board type spacer you can re-use, or you may use small washers or spacers. -Some earlier Broncos may have a different mounting pattern on the dash-

Review RetroSound In-Dash Speaker, 68-77 Ford Bronco

California residents: Proposition 65 Warning

Q&A

Have a question? Click Here to submit your question.
Know the answer? Add it here.


Your question will be published after review.


Asked by Bob, October 9, 2021

Q: Does anybody know if this speaker will fit with Vintage Air under the dash?

1 Answer

Answered by sales - October 11, 2021

A: Vintage Air says, SureFit systems may interfere with some OEM radios or in-dash speakers. Doesn't sound promising.

Know the answer? Add it here.

Know the answer? Add it here.

Asked by anthony adams, November 11, 2020

Q: will this speaker mount to the exsisting holes that the factory speaker uses?

1 Answer

Answered by sales - November 11, 2020

A: Normally yes. But, some earlier Broncos had a different mount pattern. Check your dash measurements first, then compare to the mounting dimensions on our product page.

Know the answer? Add it here.

Know the answer? Add it here.

Asked by Davey, September 23, 2019

Q: I have a 1969 Bronco with speaker vents in the dash but no holes for mounting a speaker. Will this require that I drill holes in dash?

1 Answer

Answered by sales - September 24, 2019

A: Yes, drilling new holes in the dash would be the easiest method of mounting the speaker.

Know the answer? Add it here.

Know the answer? Add it here.

Asked by Anonymous, January 4, 2017

Q: Will this fit a 66 dash? Will it fit the speaker ready fiberglass door panels?

1 Answer

Answered by sales - January 4, 2017

A: This speaker should fit your 66 dash. You will want to double check the speaker mounting hole spacing with your dash. They are too small for the speaker door panels, and do not come with any type of grille.

Know the answer? Add it here.

Know the answer? Add it here.

PRODUCT REVIEWS
patrick brown
Reviewed 03/01/2020
I have had 5 early Broncos in the past 50 years, and as always, have had excellent service and products for them from Wild Horses. Fast delivery, and products that always perform.

Al Brunjes
Reviewed 09/01/2019
I finally was able to install the Retro Speaker in my '76. I followed a cue from other reviews and used fabric to isolate the speaker from the metal dash. I chose to use a small American flag to give my dash a little pop. The speaker fits well in the original speaker location. The clips provided can be a little frustrating, but I found that crimping them to make the snug fixed the falling off problem. The speaker sounds great and is alot louder than I thought it would. Great Product in my opinion.

John Peaden
Reviewed 03/22/2019
This speaker fits perfectly in my 1977 Bronco and sounds great. Very happy with product and Wild Horses.

John Watts
Reviewed 02/02/2019
Finishing speaker for my Retrosound radio with two indoor speakers. Gives some classic depth with near stock installation.

Andrew B connell
Reviewed 01/12/2019
Fits good. Sounds. Good for single speaker

Chris
Reviewed 10/30/2017
Really happy I finally installed this speaker. Fit well and sounds great!!

Michael Sanchez
Reviewed 08/14/2017
Really good sound for small speaker

jeksbroncos
Reviewed 02/23/2016
Wild Horses new retro sound in-dash speaker is the perfect solution for Bronco owners like myself who don't want to add obtrusive speakers yet want the dual cone sound. Great product.

Brett Meehan
Reviewed 05/18/2019
The screw holes in the dash lined up perfectly with the speaker mounting holes. Easy install. Sound quality is fine


Shop popular categories
4,67 stars