RCV Dana 44 CV Front Axle Set 78-79 - WILD HORSES Full Size Ford Bronco Parts & Accessories

RCV CV Front Axle Set for Dana 44 78-79 Bronco 76-79 F150


This item will receive FREE SHIPPING to anywhere in the 48 contiguous states. The shipping charge for this item will have already been deducted from the shipping charge shown in checkout.
Customers outside of the 48 contiguous states will be emailed the shipping charges for approval prior to shipping.
Our Price: $1,499.00 $1,499.00

Description

NEW! Our RCV Dana 44 CV Front Axle Set are the Strongest Dana 44 Axles!!!

STRENGTH

We know RCV products are the best. They do in house and third party testing to ensure that these products perform at the highest level.
The 4340 alloy steel is a heat treatable and low alloy steel containing chromium, nickel and molybdenum. It has high toughness and strength in the heat treated condition.
300M alloy steel is a vacuum melted low alloy steel with the inclusion of vanadium and a higher silicon composition. It has a very good fusion of toughness, fatigue strength and good resilience. Where fracture toughness and impact strength are crucial, 300M is a great choice. 300M material is about 20% stronger than the 4340 material.

CV vs. U-JOINT

On average, RCV CV axles are almost 2X as strong as the OEM axles!!

LOW MAINTENANCE

You might be wondering if you have to re-grease these RCV Performance cv joints. Yes, but only a couple times a year because they are packed with grease! Unlike, u-joints that you have to grease almost every time you go out!
The low maintenance aspect is what I like best about the RCV axles. I have run the best of the conventional u-joint style axles but they have all been high maintenance. Jim Creel

MADE IN USA

RCV product quality cannot be matched! RCV products are made with only the highest grade materials, they only buy U.S. steel. Better materials and workmanship comes with a higher price. You get what you pay for. When our customers open the box we want them to know that they got what they paid for.
Are cv joints more expensive than u joints? The RCV Ultimate CV Joints are actually less expensive than the highest end U-joints. Even though RCV CV-Joints are almost twice as strong as the best U-joint setup out there!

DAILY DRIVERS NO PROBLEM

We encourage use of RCV products in daily drivers. They have done extenesive testing to make sure the CV axles can stand up to cross country road trips as well as hitting the trail hard. Try this with traditional highend U-joint setups, you will wear your joints out in no time!

WARRANTY

If you have a warranty issue, call us. The warranty states, "You break it, we replace it!"

Specific 78-79 Bronco info

One thing that's different (aside from the obvious) about the RCV axles is the 30 spline outer axle. The 30 spline design adds approximately 30% more contact surface between the outer axle and hub making for a much stronger outer. This necessitates a locking hub change or you can opt for drive flanges (slugs).

Due to the larger diameter of the CV joint, you must use the large opening knuckles like the 76-79 Ford disc brake knuckles. You will want to factor this in when doing a complete axle build.

™ Dana is a trademark of Dana Limited.
If the Dana logo is not shown, these parts
are not manufactured or authorized by Dana.

WARNING: This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
www.P65Warnings.ca.gov
RCV CV Front Axle Set for Dana 44 78-79 Bronco 76-79 F150
Item #: 798890
$1,499.00 $1,499.00

Product Reviews

Write a review

Challenges with RCV axles
May 23, 2017  |  By Mark
Review star icon Review star icon Review star icon Review star icon Review star icon
Ordered for dana 44 78/79 Bronco axle. Spent hours trying to figure out what spring clips would not compress to allow bearing assy to push on inner axle. Discovered rubber "O" ring was under spring clip. Removed "o" ring and assembly went right on. Called RCV yesterday and they stated that some axles had the "o" ring because of problems with bearing wondering on some lockers and axle wondering in rear. But they have since changed design to thicker spring clip. Can only figure my axle had both the "o" ring and the thicker spring clip. May save you customers some time by removing these "o" rings.

Great customer service
Feb 18, 2016  |  By Fred
Review star icon Review star icon Review star icon Review star icon Review star icon
Wild Horses has great customer service, and ship there products out very quickly I got RCV axles for my Dana 44 and so far everything is perfect.

Q&A

Close

1045 S. Cherokee Lane | Lodi, CA 95240 | (209) 400-7200

HOURS: 8:30 - 5:00 (PST or PDT), Monday thru Friday
© 1995-2019 Wild Horses Inc.
Your source for 1966 - 1979 early & full size Ford Bronco Parts
and Classic Ford Bronco 4X4 Accessories
All Rights Reserved.