Wrap Trap Axle Anti-Wrap System, 66-77 Ford Bronco SKU: 1190

The Wrap Trap™ | Early Bronco Axle Anti-Wrap System

Axle wrap is one of those problems that hits hard when you're putting real torque through your Early Bronco drivetrain. The Wrap Trap™ Axle Anti-Wrap System is built specifically to solve this issue without sacrificing ride quality, articulation, or ground clearance. Unlike traditional systems that limit suspension travel or hang too low, the Wrap Trap mounts at the centerline of the axle, maintaining full articulation while locking down rearend rotation during rock crawling and trail climbs.

Torque forces the pinion gear to try and climb the ring gear. This causes the entire rear axle housing to rotate, which can bind or even break your driveshaft. That’s axle wrap. The Wrap Trap is engineered to eliminate that rotation in both forward and reverse under low-speed torque loads—exactly the conditions that punish Broncos in technical terrain. For even better control, pair it with our Extreme Duty U-Bolt Kit and lock your axle setup in tight.

• Stops Axle Wrap Cold – Prevents damaging rearend rotation under torque in both forward and reverse

• Trail-Tested Design – Optimized for rock crawling where torque loads are highest and damage is most common

• No Loss in Suspension Travel – Center-mounted design keeps full articulation intact, unlike traditional traction bars

• Protects Rear Driveshafts – Reduces bind and stress on the lower yoke, preventing breakage during climbs or wheel hop

• Works Best With Tight U-Bolts – Combine with our Extreme Duty U-Bolt Kit for maximum drivetrain control

If you’ve ever snapped a driveshaft under load, you know axle wrap is no joke - the Wrap Trap kills axle wrap and keeps your 66-77 Bronco’s rearend locked down.