Dakota Digital Bus Interface Module for Holley EFI Systems - BIM-01-2-HLLY SKU: BIM-01-2-HLLY

Dakota Digital Bus Interface Module for Holley EFI Systems

Looking to bridge your Holley EFI system to your Dakota Digital gauges without a mess of wires and guesswork? The BIM-01-2-HLLY Bus Interface Module is exactly what you need. Whether you’re running a Holley Terminator X, Sniper, HP, or Dominator EFI system, this module delivers vital engine info straight to your Dakota Digital gauge cluster with plug-and-play simplicity. Clean, accurate, and purpose-built for Holley-powered builds—this module is your go-to solution for seamless data communication.

• Direct Plug-In Setup: Includes both 2- and 4-pin harnesses for simple, secure connection to Holley EFI systems.

• Vital Data Channels: Reads and sends tachometer, coolant temp, intake/manifold temp, fuel pressure, and air/fuel ratio to your gauges.

• Broad EFI Compatibility: Designed to work with Holley Terminator X & X Max (after 6/13/19), Sniper (after 2/1/18), HP, and Dominator units.

• Gauge System Support: Outputs data to Dakota Digital VHX, HDX, RTX, and VFD3 (rev G) control boxes with black plastic control modules.

• OEM-Level Integration: Supports available data from your Holley ECM and sensors, giving you the insight needed for performance tuning.

Additional Info

• Note on Data Availability: Output for coolant temp, intake temp, fuel pressure, and AFR is dependent on ECM and sensor configuration—accuracy may vary.

• Compatibility Warning: Not compatible with Dakota Digital aluminum control boxes or early-generation modules.

• For 3.5mm Input Systems: If your control box uses a 3.5mm headphone jack BIM input, you'll need adaptor harness part #394193.

• Built for EFI-Tuned Broncos: Ideal for high-performance builds where clean integration between electronics is critical.

Skip the guesswork - plug your Holley EFI system directly into your Dakota Digital gauge set with this Bus Interface Module for clean, real-time data delivery.