Your Cart (0)
Tapered Reamer for Knuckles SKU: 2385
Tapered Reamer for Knuckles
Tapered Reamer for Knuckles
Product Overview:
This tapered reamer will allow you to ream your existing knuckles to the larger Ford tie rods or the "GM 1 ton" steering tie rods. This is also the same tool you'd need to place your tie rods on top of the steering knuckle or what's commonly called a "Tie Rod over conversion", or TRO.
•1-1/2" taper per foot or 7.125 degree included angle.
•6 Flute straight reamer design.
•Overall length is 6-1/2", flute length is 4-1/2", major diameter is .995".
•Shank diameter is 1/2" with a square on the end.
•To be used by hand with a tap wrench, in a drill press, or vertical mill with a 1/2" or larger drill chuck or collet.
Full description
This tapered reamer will allow you to ream your existing knuckles to the larger Ford tie rods or the "GM 1 ton" steering tie rods. This is also the same tool you'd need to place your tie rods on top of the steering knuckle or what's commonly called a "Tie Rod over conversion", or TRO.
•1-1/2" taper per foot or 7.125 degree included angle.
•6 Flute straight reamer design.
•Overall length is 6-1/2", flute length is 4-1/2", major diameter is .995".
•Shank diameter is 1/2" with a square on the end.
•To be used by hand with a tap wrench, in a drill press, or vertical mill with a 1/2" or larger drill chuck or collet.
•1-1/2" taper per foot or 7.125 degree included angle.
•6 Flute straight reamer design.
•Overall length is 6-1/2", flute length is 4-1/2", major diameter is .995".
•Shank diameter is 1/2" with a square on the end.
•To be used by hand with a tap wrench, in a drill press, or vertical mill with a 1/2" or larger drill chuck or collet.
This tapered reamer will allow you to ream your existing knuckles to the larger Ford tie rods or the "GM 1 ton" steering tie rods. This is also the same tool you'd need to place your tie rods on top of the steering knuckle or what's commonly called a "Tie Rod over conversion", or TRO.
•1-1/2" taper per foot or 7.125 degree included angle.
•6 Flute straight reamer design.
•Overall length is 6-1/2", flute length is 4-1/2", major diameter is .995".
•Shank diameter is 1/2" with a square on the end.
•To be used by hand with a tap wrench, in a drill press, or vertical mill with a 1/2" or larger drill chuck or collet.
•1-1/2" taper per foot or 7.125 degree included angle.
•6 Flute straight reamer design.
•Overall length is 6-1/2", flute length is 4-1/2", major diameter is .995".
•Shank diameter is 1/2" with a square on the end.
•To be used by hand with a tap wrench, in a drill press, or vertical mill with a 1/2" or larger drill chuck or collet.
California residents: Proposition 65 Warning
Q&A
Have a question? Click Here to submit your question.
PRODUCT REVIEWS
Shop popular categories