Steering Drag Link | Inverted Y-Style | 76-77 Ford Bronco SKU: 2299

Steering Drag Link | Inverted Y-Style | 1976–77 Ford Bronco

If your steering feels loose and unpredictable, this OE-correct Inverted Y-Style Steering Drag Link is a critical component in restoring proper steering control on your 1976–77 Ford Bronco. Built as a direct reproduction of the factory drag link, it connects the steering gear pitman arm to the passenger-side steering knuckle while also providing the upper mounting point for the driver-side inner and outer tie rod assembly.

Measuring approximately 42 inches long, this drag link is designed specifically for the factory inverted Y steering setup used only on 1976-77 Ford Broncos. It bolts directly into place using factory-style components, making it a straightforward replacement when your original drag link is worn, bent, or damaged.

Pro Tip: If this drag link is worn, chances are the rest of the steering linkage isn’t far behind. For best results, we strongly recommend replacing the drag link as part of a complete steering linkage refresh to restore tight, predictable steering.

• OE-Correct Inverted Y Design – Matches the factory steering geometry used on 1976–77 Ford Broncos

• Direct Pitman-to-Knuckle Connection – Links the steering gear pitman arm to the passenger-side knuckle

• Integrated Tie Rod Mount – Center provision allows the driver-side inner and outer tie rod assembly to connect

• Approx. 42" Overall Length – Built to factory dimensions for proper fit and alignment

• Factory-Style Replacement – Works with original-style steering components

Additional Info

• Fitment: 1976–77 Ford Bronco

• Steering Style: Inverted Y

• Installation: Direct bolt-on replacement

Restore your 76-77 Bronco steering to OE-correct operation with this Y-style drag link—made to fit right, steer right and keep your Bronco driving as it should.

• For use with factory steering tie rods. Highly recommend replacing complete steering linkage at the same time.