San Felipe Front Weld-In Cage Kit, 66-77 Ford Bronco SKU: 4253
San Felipe Front Weld-In Cage Kit, 66-77 Ford Bronco
Product Overview:
Got the San Felipe tube bar? Here's an easy add-on to add protection to the cab area. Side braces extend from the floor to the top of windshield and bend toward your existing rear bar. A spreader bar runs parallel to the windshield.
Full description
Early Bronco Front Weld-in Cage for San Felipe Roll Bar
Upgrade the Wild Horses San Felipe roll bar on your 66-77 Ford Bronco with this weld-in front cage. Made from sturdy 2" x .120 wall steel. This is an easy add on to the early Bronco San Felipe tube roll bar. Requires removal of top and welding for installation. Comes with side braces that extend from floor to the top of the windshield and bend toward the existing rear bar. A spreader bar is included to run parallel to the windshield. Installation hardware included.Q&A
Have a question? Click Here to submit your question.
Asked by JOEL RODRIGUEZ, November 13, 2020
Q: What size are the front SAN FELIPE floor mount plates?.. I'm looking to tie in my cage to the frame and want to know what plates you guys use. Thank you
Answered by ☆ sales - November 18, 2020
A: The floor plates for the main hoop are approximately 4.5 x 3 at the floor. The rear supports are approx. 3 x 3.
Asked by Ray Bolton, May 12, 2020
Q: Will this kit fit a 1976 cj5
Answered by ☆ sales - May 13, 2020
A: It is only designed for the 66-77 Bronco with no bulkhead. You may be able to adapt it for your application, but we do not know how or if it will fit.
Asked by Jeff, December 2, 2019
Q: Can this Interior Bar addition work with my existing bar? I do not believe it is the SanFelipe bar already installed but very similar.
Answered by ☆ sales - December 4, 2019
A: If your current bar is shaped like the San Felipe, with the rear support bars back by the tailgate over the wheel wells, you should be able to make it work. This kit does not have floor plates, and must completely tie in to the existing bar.
Asked by Michael G. Hazelett, April 27, 2019
Q: Sir,Will your front driver roll bar fit a 54 inch wide bronco 2?
Answered by ☆ sales - May 1, 2019
A: Sorry, no, it is only designed for the 66-77 Bronco Wagon.
Asked by Anonymous, December 23, 2015
Q: Can this be made to fit in a half cab with the top on?
Answered by ☆ sales - December 29, 2015
A: Yes it can, it will need to be trimmed to fit, and fitted for your application.
Asked by Marc, June 12, 2014
Q: Does this product allow clearance for wiper motor?
Answered by ☆ sales - June 18, 2014
A: When properly installed YES.