Dana 44 Spindle Studs + Nuts Kit | 3/8-in | Reid Racing Knuckles SKU: 8707

Dana 44 Spindle Studs + Nuts Kit | 3/8-in | Reid Racing Knuckles

Product Overview:

Secure your spindle to Reid Racing Dana 44 6-Bolt Flat Top Knuckle with this 3/8" Knuckle Spindle Stud Kit. This heavy-duty kit is designed to fasten the 6-bolt spindle to your knuckle with strength and precision—ideal for off-road builds, upgrades, or reliable OE replacement. Includes six studs and nuts.

Set of six (6) Knuckle Studs & six (6) Nuts - Enough for one (1) steering knuckle.

Full description

Set of six (6) Knuckle Studs & six (6) Nuts - Enough for one (1) steering knuckle.

3/8" Knuckle Spindle Studs w/ Nuts | Reid Racing 6-Bolt

Lock Down Your Spindle with Confidence

These 3/8" Knuckle Spindle Studs are built to secure your spindle to the knuckle with strength you can trust—on or off the trail. Designed for use with Reid Racing 6-Bolt Dana 44 steering knuckles, these studs hold your 6-bolt spindle firmly in place for dependable front-end performance.

Compatible with Reid Racing Dana 44 Flat Top Knuckles
Secures 6-Bolt Ford Spindles – Locks spindle to knuckle with heavy-duty hardware
Includes Studs and Nuts – One complete kit per knuckle
Two Kits Required Per Vehicle – One for each side

Whether you're doing a fresh build or replacing worn hardware, this kit provides the secure fit and strength your steering and axle setup depends on.

California residents: Proposition 65 Warning

Questions & Answers

PRODUCT REVIEWS

Scott

Reviewed 03/06/2018

These 6 little studs are all that hold the spindle+rotor+wheel+tire onto your axle! I feel much better about these than I did about the grade 8 bolts that are used on the stock knuckle. Being studs, they also make installation easier.

Dale

Reviewed 05/27/2015