Extreme Duty Output System for Dana 20 and 1350 shaft w/ Speedometer Parts SKU: 8284KITNET

Extreme Duty Dana 20 Transfer Case Output | 1350 Shaft with Speedo Parts

Upgrade your 66-77 Ford Bronco drivetrain with confidence using our Extreme Duty Dana 20 Transfer Case Output System, built to handle the torque and stress of high-horsepower engines, big tires, and serious off-road abuse. This bolt-in assembly replaces the weak factory output shaft with a longer, stronger 1350-series flange, allowing you to run a heavy-duty 1350 U-joint driveshaft—perfect for performance builds and trail rigs alike.

This output system is approximately 1.3 inches longer than stock and comes fully assembled, ready to install right out of the box. The kit includes the speedometer gear, housing, and cable, so you're covered on both performance and function.

• Fits Dana 20 Transfer Case – Engineered for 1966–77 Ford Bronco

• Completely Assembled Unit – Pre-built and ready to bolt in with no guesswork

• Upgraded 1350-Series Flange – Supports larger, stronger driveshafts for extreme applications

• Adds ~1.3 Inches of Length – Check that you have the correct driveshaft length after install

• Includes Speedometer Parts – Comes with gear, housing, and cable for a complete installation

• Compatible with WH 1350 Driveshafts – Custom shafts available by special order

Built for serious torque and trail punishment - this bolt-in Extreme Duty Early Bronco Dana 20 output replaces weak factory parts for a major strength upgrade.