Upper & Lower Dana 44 Ball Joints, 71-77 Ford Bronco SKU: 8828

Early Bronco Dana 44 Upper & Lower Ball Joints | 1971–77 Ford Bronco

Steering feeling sloppy? This Dana 44 Upper & Lower Ball Joint Set could be the fix your 1971–77 Ford Bronco needs. This kit includes a pair of upper and lower ball joints—enough to rebuild one steering knuckle. You'll need two sets to fully restore both sides of your Dana 44 front axle. Worn ball joints are a major cause of wandering steering, uneven tire wear, and poor handling. Swapping them for these high-quality replacements helps eliminate play and tighten up your ride.

Pro Tip: Want to check if your ball joints are toast? Just lift the front end and rock the wheel by grabbing the top and bottom of the tire. If you feel movement, your ball joints are worn and ready to be replaced.

• Does One Steering Knuckle: Includes one upper and lower ball joint—enough to rebuild a single side of your Dana 44 front end.

• Vehicle-Specific Fit: Designed specifically for the 1971–77 Ford Bronco with a Dana 44 front axle.

• Restore Steering Precision: Replacing worn ball joints tightens up steering and improves handling.

• Durable Construction: Made from high-strength materials built to handle off-road abuse and long-term wear.

• Essential for Suspension Rebuilds: A must-have for any front-end refresh, especially if you're chasing alignment or stability issues.

For sloppy steering, these upper and lower ball joints could be the cure - restore proper handling and eliminate front-end play in your 1971-77 Bronco Dana 44.