Pertronix Flame Thrower HC 60000-Volt E-Core (0.32 OHM) for Ignitor III

Item #: 8108
The ultimate companion for your Pertronix Ignitor III system! This 60,000 volt HC (high-current) E-core coil is specifically designed for use with the Ignitor III.
Price:

Description

Our new HC E-core (epoxy filled) design is a perfect partner for the Ignitor III®. The new 60,000 volt High Current design has a high turns ratio and ultra low primary resistance enabling the ignition system to charge faster at high RPM's. This design enables a rapid charge rate (typically 36% to 60% faster than most coils). The coil is supported in a special heat sink made from aircraft 6063 T5 aluminum which efficiently transfers heat away from the windings.

    Features
  • 60,000 volts
  • Ultra Low 0.32 primary resistance
  • Compatible with Ignitor III systems only.
  • Charges to peak current typically 36-60% faster than other coils.
  • Rapid charge time means maximum spark energy is sustained to higher engine RPM
  • Highly efficient E-core design.
  • Vacuum potted coil body for longer life and increased reliability.
  • 6063 T5 aluminum heat sink with black anodized corrosion resistant finish.
  • Precision machined male high tension terminal and brass primary terminals.
  • Legal in all 50 states and Canada. (C.A.R.B. E.O. #D-57-10)

WARNING: This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
www.P65Warnings.ca.gov
Pertronix Flame Thrower HC 60000-Volt E-Core (0.32 OHM) for Ignitor III
Item #: 8108

Q&A

Close