Steel 6 Degree Shims - WILD HORSES Early Ford Bronco Parts

The steel 6 degree shims are 2 1/4" wide and machined for WH. These are not cast, they will hold up under extreme conditions. The shims are used to help adjust rear end pinion angle. They come with new center bolts.

CLICK HERE for Installation Instructions

Shims

Feb 11, 2013 | By Dmh

Much better quality then I took off

MOSQUITO COUNTY STEVE

Mar 1, 2012 | By MOSQUITO COUNTY STEVE

COOLER THAN "DANG IT" I WISH I HAD DONE THESE 6 DEGREE SHIMS 20 YEARS AGO. NO MORE BRONCO CLUNK OR VIBRATION. IF YOU HAVE THE BRONCO DRIVESHAFT CLUNK/VIBRATION THEN DO THIS IMMEDIATLEY. YOU WILL NOT BE SORRY! '73 WAGON, BUITL WINDSOR, HEAVY BUMPERS & WINCH, WH 3.5" LIFT.

MOSQUITO COUNTY STEVE

Feb 21, 2012 | By MOSQUITO COUNTY STEVE

GREAT PRODUCT AS USUAL. IF RE-DRILLING SPRINGS TO THE 7/16ths SIZE, IT IS VERY DIFFICULT.

OZZY

Oct 16, 2011 | By David Card

I needed my pins fast. you guys got them to me just like you said by Wednesday. I left the next mourning for an event in NH. And while checking the pin I broke 3 weeks earlier, I noticed that the other side had broke, I had not even gotten on the trail, and needed a new pin. It all worked out, then I split my steering box for the second time, still had a blast.

Great Shims

Jul 26, 2011 | By Jeff Dias

Bronco was chewing up U Joints. Theses shims worked great. Truck has 3 1/2" lift.

6 Degree Axle Shims

Jul 11, 2010 | By BDiefAZ

Great product, excellent quality, and solved driveline vibration issue on my Bronco with 3" lift. I would reccomend this product, my only regret is that I did not install these sooner.

Write a review