CALL US WE'RE OPEN

209 943-0991

HOURS: 8:30-5:00 PST 640 N El Dorado St. Stockton, CA 95202

Huge inventory of 1966-1979 Ford Bronco and other off-road vehicle parts. Great prices and unmatched service from experienced Bronco builders.

Painless 12-Circuit Wiring Harness for pickups with Non-GM Keyed Column (Non Fuel Injected engine and Non Electronic Transmission)
This Painless 12 Circuit kit can be used in just about any pickup where basic or more wiring is needed. Ample wire lengths make this kit especially suited for everything included trucks with long beds and extended cabs. This kit does NOT included the GM column mounted ignition switch plugs but includes the GM column mounted turn signal switch plugs and terminals.

Number of Circuits: 12 Fuses w/ Horn Relay and Maxi Fuse
Harness Length: Universal
Fuse Type: Blade & Maxi Fuse
Firewall Passthrough: Grommet
Color Code Based: GM
Connectors Included: GM Steering Column Turn Switch, Two Headlight Pigtails, 10SI & 12 SI Alternator, Dimmer Switch
Circuit Designations: Printed on Wires

This harness includes circuits for:

1. Headlight Switch- Power to headlight switch. Power wires out of headlight switch to head light dimmer switch, tail lights, dash lights and park lights.
2. Dimmer Switch wires include power from headlight switch and power out to low and high beam headlights.
3. Wiper Switch- Power to wiper switch. You will need to retain the wires between the wiper switch and your wiper motor.
4. Turn Signal Switch- Power into and out of your column mounted turn signal switch. Also included in this kit are both styles of GM turn switch connectors. Note: these will connect to most aftermarket and factory steering columns.
5. Ignition Switch- Power into and out of to fuse block (ignition, crank and accessory)
6. Brake Switch- Power into and out of brake switch. This includes a third brake light wire.
7. Courtesy Lights- Power and ground circuits for dome light activation.
8. Alternator- Charge wire and alternator field activation wires. (Most alternators can easily be wired up to this Painless harness). Included in kit is a high output alternator wire that allows you to use up to a 140 Amp alternator.
9. Horn- 40 Amp horn relay mounted to fuse block
10. Radio- Harness includes constant B+ (for preset memory) and ignition hot circuits for any aftermarket or factory radio.
11. Starter- Crank signal wire for starter solenoid.
12. Engine section wires including electric choke, coil power, coil to tach signal, oil pressure, engine temperature, and A/C compressor clutch control wire.
13. Headlight section wires including right and left high and low beam headlights, turn signals and park lights.
14. Tail section wires including tail lights, brake lights, turn signal lights, fuel gauge sender, third brake light, and reverse lights.
15. Dash panel section wires including fuel, temperature, oil pressure, voltage, tachometer, speedometer, high beam and turn indicators and gauge illumination.
16. Also included in kit is a fuse block mounting bracket, rubber grommet, 4 inch zip ties, 70 Amp maxi fuse and a large assortment of crimp style connectors.

Most important of all, Painless provides an illustrated installation manual that equips you with the needed information to install the harness to your vehicle. If you get stuck during the installation just give their tech line a call. They have an immense data base of vehicle specific information.